POWERHEAD
Page 4A-42 90-884294 OCTOBER 2001
IMPORTANT: Warming the piston dome using a torch lamp will ease removal and in-
stallation of piston pin.
13. Support piston and tap out piston pin using service tool (91-92973A1) as shown.
55957
b
a
a-Piston Pin
b-Piston Pin Tool (91-92973A1)
14. Remove piston pin needle bearings (34 per piston) and locating washers (2 per piston)
as shown.
IMPORTANT: It is recommend that new needle bearings be used at reassembly for
lasting repair. However, if needle bearings must be re-used, keep each set of bearings
identified for reassembly on same connecting rod.
55958
a
a-Needle Bearing Locating Washers
To Next Page
Loading...
