Mercury 225 EFI - Page 426

CLAMP/SWIVEL BRACKETS & DRIVE SHAFT HOUSING
90-884294 OCTOBER 2001 Page 5A-15
19. Install lower mount retainers and secure each retainer with 2 bolts. Secure ground
strap with the nearest retainer bolt and flat washer. Torque bolts to 20 lb. ft. (27 Nm).
20. Install lower mount covers and secure each cover with a screw.
52308
52307
c
b
a
e
d
a-Lower Mount Retainer
b-Bolts [Torque to 20 lb.
ft. (27 Nm)]
c-Ground Strap
d-Cover
e-Screw (1 for each cover)
21. Install upper mount cover on adaptor plate. Secure cover with 3 bolts. Torque bolts
to 20 lb. ft. (27 Nm).
22. Route power trim harness thru grommet in adaptor plate.
23. Reinstall shift shaft with bushing into adaptor plate. Apply 2-4-C Marine Lubricant with
Teflon to bushing.
58005
a
d
95
2-4-C Marine Lubricant with Teflon
95
b
c
e
f
g
a-Shift Shaft Linkage
b-Exhaust Adaptor Plate
c-Upper Mount Cover
d-Bolts [Torque to 20 lb.
ft. (27 Nm)]
e-Power Trim Harness
f-Grommet
g-Bushing