CLAMP/SWIVEL BRACKETS & DRIVE SHAFT HOUSING
Page 5A-14 90-884294 OCTOBER 2001
7. Apply a small amount of Perfect Seal onto metal portion of upper dyna-float mounts.
8. Position mounts on drive shaft housing plate.
9. Install a rubber washer onto each upper mount, followed by a metal washer.
10. Push bolts through mounts.
58004
a
b
b
c
c
Perfect Seal
19
19
19
a-Dyna-Float Mounts
b-Rubber Washers
c-Metal Washer
11. Install a ground strap onto port lower mount bolt.
NOTE: Apply Perfect Seal along length of lower mount bolts.
12. Insert a mounting bolt through the short end of each lower mount.
13. Position a mount on each lower side of drive shaft housing.
14. Install a flat washer over each lower mounting bolt.
15. Start upper mounting bolts in upper mounts and align lower mounting bolts with holes
in swivel pin yoke. Slide drive shaft housing up against yoke and bumper.
16. Secure upper mounts to steering arm with flat washers and self-locking nuts. Torque
nuts to 50 Ib. ft. (68 Nm).
17. Install ground strap between port lower mount bolt and swivel bracket.
18. Secure lower mounts to swivel pin yoke with self-locking nuts. Torque nuts to 90 Ib.
ft. (122 Nm). Place a rubber cap over each lower mounting bolt head.
52308
e
d
b
c
a
a-Lower Mount
b-Nut [Torque to 90 lb. ft.
(122 Nm)]
c-Rubber Cap
d-Ground Strap (only 1 side)
e-Ground Strap (to swivel bracket)
To Next Page
Loading...
