RIGHT HAND NON-RATCHETING
Page 6A-24 90-884294 OCTOBER 2001
BEARING CARRIER ASSEMBLY Component Reassembly
NOTE: Complete the instructions in this section only if the assembly components have
been disassembled and repaired or replaced.
1. Clean all of the components with a suitable solvent and dry the parts thoroughly using
compressed air. Be careful not to spin the bearing.
2. Lubricate the bore that the needle bearing is pressed into with Premium Gear Lubri-
cant.
3. Assemble the needle bearing (with the numbered end of the bearing towards the driv-
er shoulder), onto the driver.
4. Press the needle bearing into the bearing carrier until the driver bottoms out on the
bearing carrier. Ensure that the numbered side of the needle bearing faces the seal
end (aft end) of the carrier.
50315
87
a
b
c
87
Premium Gear Lubricant
a-Needle Bearing Driver (91-15755)
b-Needle Bearing
c-Bearing Carrier
To Next Page
Loading...
