RIGHT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6A-25
5. Thoroughly clean the bore in which the first seal is to be pressed.
6. Assemble the first seal (with the lips of the seal facing away from the driver shoulder)
onto the long end of the oil seal driver.
7. Press on the oil seal driver until the driver bottoms on the bearing carrier.
50315
a
b
c
a-Oil Seal Driver
(91-31108)
b-Oil Seal
c-Bearing Carrier
8. Apply a thin film of Loctite 271 to the outer diameter of the second seal.
9. Assemble the second seal (with the lips of the seal facing the driver shoulder) onto
the short end of the driver.
10. Press the oil seal with the driver until the driver bottoms out on the bearing carrier.
50315
7
Loctite 271
95
2-4-C Marine Lubricant With Teflon
7
95
a
b
c
a-Driver (short end)
b-Oil Seal (lips toward driver shoulder)
c-Bearing Carrier
11. Wipe up all of the excess Loctite. Do not allow any of the excess Loctite to spread to
other parts of the assembly.
12. Lubricate the seal lips and fill the area between the seals with 2-4-C Marine Lubricant
with Teflon.
To Next Page
Loading...
