RIGHT HAND NON-RATCHETING
Page 6A-28 90-884294 OCTOBER 2001
e. If the drive shaft is broken, place propeller shaft nut wrench onto the propeller
shaft splines, hold shift shaft in forward gear and loosen
, (but do not fully un-
screw), the pinion nut by rotating prop shaft counterclockwise to turn gears, thus
loosening the pinion nut.
NOTE: The propeller shaft nut wrench is included with the pinion nut adapter kit
70607
a
b
c
a-Pinion Nut Adaptor (MR slot) (91-61067A2)
b-Propeller Shaft Nut Wrench (91-61067)
c-Shift Shaft (Turn Clockwise) (Protect shaft splines with soft material)
f. Completely unscrew the drive shaft bearing retainer.
g. Completely unscrew the pinion nut by rotating the drive shaft (or the propeller
shaft) in a counterclockwise direction.
h. Remove all tools.
IMPORTANT: The pinion bearing rollers are free to fall out of the pinion bearing
once the drive shaft is removed. Be careful not to loose the (18) rollers.
2. Remove the drive shaft and all components by pulling the drive shaft straight out of
the gear housing as shown.
70608
a
b
a-Drive Shaft
b-Drive Shaft Retainer, Bearing Cup, Bearing, and Shims
3. Move the prop shaft downward and to the PORT side of the gear case.
4. Retrieve the pinion gear, the washer and the nut from the inside of the gear housing.
To Next Page
Loading...
