RIGHT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6A-29
NOTE: If pinion gear is seized onto the driveshaft, place gearcase in vise using soft jaw
vise covers. Place a block of wood on gear housing mating surface. Use a mallet and care-
fully tap gear housing away from drive shaft.
CAUTION
Do not strike gear housing hard with mallet or allow gear housing to fall.
57951
a
b
a-Wood Block
b-Drive Shaft in Soft Jaw Vise
5. Remove lower drive shaft bearing cup and shims using slide hammer puller
(34569A1) (retain shims for re-installation).
a
b
a-Slide Hammer Puller (91-34569A1)
b-Lower Drive Shaft Bearing Cup
To Next Page
Loading...
