LEFT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6B-63
2. Apply Loctite 271 to the threads of the pinion gear nut and place the pinion gear nut
into the MR slot of the pinion nut adapter.
NOTE: Install the pinion gear nut with the flat side of the nut away from the pinion gear.
3. Place the pinion gear (with the washer glued to it) into the gear housing.
4. Insert the drive shaft into the gear housing drive shaft bore. It may be necessary to
rotate the drive shaft to engage the drive shaft splines into the pinion gear splines.
5. Temporarily install the propeller shaft (without the sliding clutch installed) into reverse
gear.
6. Insert the pinion nut adaptor (with the nut) into the gear housing. It may be necessary
to raise the drive shaft slightly to clear the tool.
7. Start the pinion nut onto the drive shaft threads by rotating the drive shaft until the nut
is snug.
57952
c
a
b
a-Pinion Gear (with the washer glued to it)
b-Pinion Nut Adaptor (91-61067A2)
c-Drive Shaft
8. Install the upper drive shaft tapered roller bearing cup. Apply 2-4-C Marine Lubricant
with Teflon to the retainer threads and install the retainer.
57953
a
b
a-Upper Tapered Roller Bearing Cup
b-Drive Shaft Retainer
To Next Page
Loading...
