LEFT HAND NON-RATCHETING
Page 6B-64 90-884294 OCTOBER 2001
9. Install the bearing carrier into the gear housing backwards to hold the propeller shaft
and the pinion nut adaptor in position.
10. Torque the pinion nut to 70 lb. ft. (95 Nm) by turning the drive shaft using the drive shaft
nut wrench and torque wrench.
57950
b
c
a
a-Pinion Nut Adapter (91-61067A2)
b-Drive Shaft Nut Wrench (91-56775)
c-Bearing Carrier (installed backwards)
11. Remove the bearing carrier, pinion nut adapter and drive shaft nut wrench.
12. Torque the retainer to 100 lb. ft. (135 N·m).
57935
a
a-Drive Shaft Bearing Retainer Wrench (91-43506)
13. Remove retainer wrench.
To Next Page
Loading...
