LEFT HAND NON-RATCHETING
90-884294 OCTOBER 2001 Page 6B-83
3. To allow for the engagement of the shift spool with the shift crank, tilt the propeller end
of the propeller shaft assembly to the left (port) side of gear housing and begin to lower
it into the gear housing.
50888
b
a
c
a-Shift Actuating Spool
b-Shift Crank
c-Propeller Shaft Assembly
4. With the propeller shaft assembly tilted to the port side of the gear housing, continue
to lower the assembly until the reverse gear hub comes into contact with the reverse
gear bearing adaptor and the propeller shaft is fully inserted into the reverse gear.
50888
a
b
c
a-Propeller Shaft
b-Reverse Gear Hub
c-Bearing Adaptor
To Next Page
Loading...
