LEFT HAND NON-RATCHETING
Page 6B-84 90-884294 OCTOBER 2001
5. Slowly move the propeller shaft to the center of the housing and lower the reverse
gear into the bearing adaptor. The shift spool should engage with the shift crank as
the propeller shaft centers itself.
50885
a
b
d
c
a-Reverse Gear
b-Bearing Adaptor
c-Shift Spool
d-Shift Crank
6. Operate the shift shaft to ensure that it has been properly installed. The sliding clutch
should move forward when the shift shaft is turned clockwise, and should move aft
when the shift shaft is turned counterclockwise.
7. Make sure that the O-rings are present and positioned correctly. Install the screws that
secure the shift shaft bushing and torque them to 60 lb. in. (7 Nm).
8. Slide the rubber sleeve at top end of shift shaft down so that it just touches the oil seal
in the bushing.
57933
b
a
c
d
a-Screws [Torque to 60 lb. in. (7 Nm)]
b-Shift Shaft Bushing
c-Rubber Sleeve
d-Shift Shaft
To Next Page
Loading...
