LEFT HAND NON-RATCHETING
Page 6B-98 90-884294 OCTOBER 2001
4. Install the 2 water pump locating pins through the gaskets and face plate.
5. Apply a light coat of 2-4-C Marine Lubricant with Teflon to the inside of the pump cover.
Position the water pump body over the drive shaft and water pump locating pins. Ro-
tate the drive shaft in a clockwise direction, while pushing down on the water pump
body to ease the water pump over the impeller blades.
57942
95
2-4-C Marine Lubricant with Teflon
b
a
c
95
a-Water Pump Body
b-Water Pump Alignment Pins (91-821571A1)
c-Drive Shaft (turn clockwise while installing water pump body)
6. Hand start two (2) fasteners into the water pump assembly and remove the water
pump locating pins. Install the remaining 2 fasteners. Run all fasteners down and
torque to 60 lb. in. (7 Nm).
7. Lightly lubricate the O-rings in the water tube coupling with 2-4-C Marine Lubricant
with Teflon.
8. Install the water tube coupling assembly to the water pump ensuring that the O-rings
are not damaged during assembly.
IMPORTANT: If seal installed above pump housing is not at the proper height, air
will be drawn into the pump resulting in overheating of the engine.
To Next Page
Loading...
