Maintenance for white ink
4-31
4
Maintenance
6
Slowly shake the white ink cartridge more than twenty times right and left.
• To prevent ink from leaking when you shake the cartridge, wear gloves and firmly cover the A part of the
upper surface of the cartridge and the B part of the bottom surface of the cartridge with paper towels.
Then, shake it more than twenty times right and left so that ink flows inside the cartridge.
7
When a screen shown in the right is displayed,
return the two white ink cartridges to the ink station.
• As shown in the drawing, set an ink cartridge turning up a side
containing the IC chip.
• When the two white ink cartridges are set, white ink filling
starts. (When the ink set is “W CL”, set the white ink cartridge
and the clear ink cartridge.)
8
When a message shown in the right is displayed after
completion of white ink filling, press the key to
finish.
• If you shake it too strong, the pack inside may be damaged and it may cause ink leakage. Therefore,
perform this carefully.
• If the remaining amount of ink is less, ink in the cartridge cannot be beaten enough. Tilt the cartridge
until it becomes vertical.
Part A
(Insertion hole of the needle)
Part B
(Gap on the bottom surface)
Cover with paper towel
firmly and shake ink slowly
Repeat this
A part
To Next Page
Loading...
Need help?
General