MIMAKI UJF-3042HG - Setting of Fan Mode

3-17
Various settings
3
Useful Function
Setting of fan mode
When you use the vacuum table, you can set whether the vacuum function to fix the media set on the vacuum
table is performed automatically or you perform it manually.
The factory default is “AUTOMATIC”. (Supported from the firmware ver.3.00)
1
Press the key in the local mode.
2
Press the [SET UP] by pressing the or key,
and press the key.
3
Select the [FAN MODE] by pressing the or
key, and press the key.
4
Select the “AUTO” or the “MANUAL” by pressing the
or key, and press the key.
• AUTOMATIC : When you turn ON the vacuum function
automatically before drawing
• MANUAL : When you switch ON/OFF of the vacuum depending
on the media to be set
5
Press the key several times to end the setting.
<LOCAL>
FUNCTION
FUNCT I ON
WOR K S E T < E N T >
ENTER
SET UP
FAN MODE <en t >
ENTER
SET UP
FAN MODE : AUTOMAT IC
ENTER
END