2-12
Execution of head cleaning
When a correct pattern is not obtained in the test drawing, perform the head-cleaning. As for the head cleaning,
the following 3 types are available.
1
Press the key in the local mode.
2
Select the head, set execution/non-execution of cleaning,
and press the key.
(1) Select the head with or keys.
(2) Select execution/non-execution of the head cleaning with
or keys.
Select execution of cleaning for every head.
Execute Cleaning:Head No. being set is displayed.
Not Execute Cleaning:“ - ” is displayed.
3
Select the cleaning type with or keys, and
press the key.
4
Press the key.
• Cleaning is started.
• When the cleaning is completed, a mode is returned to the local mode.
5
Execute test drawing and check the result of the test drawing.
• Repeat cleaning and test drawing until normal result is obtained.
normal
To be used if ten odd numbers of the lines are missing when the test pattern is made.
Suction and wiping will be performed.
hard To be used when the missing of the lines does not improve with the “normal” cleaning.
soft To be used when the lines are curved.
To Next Page
Loading...
Need help?
General