Routine maintenance
4-3
4
Maintenance
Cleaning exterior surfaces
If exterior surfaces of the machine is dirty, dampen a soft cloth with water or a neutral detergent diluted with
water, squeeze it and wipe the surfaces.
Cleaning the table
The table is easy to become dirt with lint, paper dust or the like after cutting media.
For a conspicuous stain, wipe it off with a soft-hair brush, a dry cloth, a paper towel or the like.
• Be sure to clean the slot on the frame of the table, the screw holes for holding tools or the like since dust
and dirt are easily accumulated in these parts.
• If it is stained with ink, wipe it off with a paper towel containing a little amount of the cleaning solution.
To Next Page
Loading...
Need help?
General