MIMAKI UJF-3042HG - Interruption of Drawing

2-14
4
Start drawing.
• The drawing origin is not changed after completion of the drawing.
5
Taking out the media after completion of drawing.
(1) When you made vacuum ON, Press the key to turn the adsorption OFF.
(2) Remove the media.
Interruption of drawing
To interrupt drawing, stop the drawing operation and erase the received data from the machine.
1
Press the key while drawing.
• Drawing operation stops.
• When data is transmitted from the computer, the computer stops
transmission of data.
2
Press the key.
3
Press the key.
• Received data is erased and the machine returns to the local mode.
Y-bar moves to the evacuation position.
• When you use the vacuum function of the vacuum table to draw, turn OFF the vacuum when drawing
has been completed. (P.3-30 “Set the vacuum function”)
• During printing, media may be heated by the LED UV and raised, causing drawing to be interrupted. In
this case, set new media and restart drawing.
• To restart drawing, press the key again.
VACUUM
<LOCAL>
REMOTE
REMOTE
DATA CLEAR
<ENT>
DATACLEAR
** DATA CLEAR **
ENTER