1-7
1
Before Use
About vacuum table
It is necessary to adjust the table height depending on the media thickness because various media can be set for
drawing.
This machine provides you with two jigs for adjusting the table height (vacuum tables).
The specification of each table is as less:
Table Vacuum table +
Table spacer 50
Vacuum table +
Table spacer 100
Acceptable media weight
*1
*1. If you put a heavier thing than specified, the quality image may be degraded.
UJF-3042HG: 5kg and less
UJF-6042: 7kg and less
UJF-3042HG: 2kg and less
UJF-6042: 4kg and less
Vacuum function
None
Yes (Setting is required. P.3-30)
Table movable area
0 to 50mm 50 to 100mm 100 to 150mm
Media thickness
100 to 150mm Between 50mm and 100mm 50mm and less
To Next Page
Loading...
Need help?
General