Mindray BeneView T8 Operation Manual

Contents
6
13.3.2 Using a Microstream CO
2
Module................................................................. 13-4
13.3.3 Using a Mainstream CO
2
Module .................................................................. 13-5
13.4 Changing CO
2
Settings ............................................................................................... 13-6
13.4.1 Accessing CO
2
Menus.................................................................................... 13-6
13.4.2 Changing the Operating Mode ....................................................................... 13-6
13.4.3 Setting the Pressure Unit ................................................................................ 13-6
13.4.4 Setting up CO
2
Compensations...................................................................... 13-7
13.4.5 Humidity Compensation for Side/Microsctream CO
2
Readings.................... 13-7
13.4.6 Setting the Apnea Alarm Delay...................................................................... 13-8
13.4.7 Choosing a Time Interval for Peak-Picking ................................................... 13-8
13.4.8 Setting up the CO
2
Wave................................................................................ 13-8
13.4.9 Setting the Automatic Standby Time.............................................................. 13-9
13.5 Troubleshooting the Sidestream CO
2
Sampling System ............................................. 13-9
13.6 Removing Exhaust Gases from the System ................................................................ 13-9
13.7 Zeroing the Sensor .................................................................................................... 13-10
13.7.1 For Sidestream and Microstream CO
2
Modules........................................... 13-10
13.7.2 For Mainstream CO
2
Modules ..................................................................... 13-10
13.8 Calibrating the Sensor ................................................................................................13-11
13.9 Oridion Information ...................................................................................................13-11
14 Monitoring AG ............................................................................................................. 14-1
14.1 Introduction................................................................................................................. 14-1
14.2 Identifying AG Modules ............................................................................................. 14-1
14.3 Understanding the AG Display ................................................................................... 14-2
14.4 Connecting AG Accessories........................................................................................ 14-3
14.5 Changing AG Settings................................................................................................. 14-4
14.5.1 Accessing AG Menus ..................................................................................... 14-4
14.5.2 Selecting an Anesthetic Gas for Monitoring .................................................. 14-4
14.5.3 Setting the Apnea Alarm Delay...................................................................... 14-4
14.5.4 Changing the Sample Flow Rate.................................................................... 14-4
14.5.5 Setting up the O
2
Compensation .................................................................... 14-5
14.5.6 Changing the Operating Mode ....................................................................... 14-5
14.5.7 Setting the Automatic Standby Time.............................................................. 14-5
14.5.8 Setting up the AG Wave ................................................................................. 14-5
14.6 Troubleshooting .......................................................................................................... 14-6
14.6.1 When the Gas Inlet is Blocked....................................................................... 14-6
14.6.2 When Internal Occlusions Occurs.................................................................. 14-6
14.7 Removing Exhaust Gases from the System ................................................................ 14-6
15 Monitoring ICG............................................................................................................ 15-1
15.1 Introduction................................................................................................................. 15-1
15.2 Safety .......................................................................................................................... 15-1
15.3 Understanding ICG Parameters................................................................................... 15-2
15.3.1 Measured Parameters ..................................................................................... 15-2

Mindray BeneView T8 Specifications

General

Brand	Mindray
Model	BeneView T8
Category	Monitor
Language	English