Mindray DC-T6 - Manage Settings; Exporting Setup Data

15-22 Setup
Name Description
Service Name The name of the network service, cannot be empty
Destination
Device
Name of the device, cannot be empty
IP Address IP address of the network service device, cannot be empty
Ping Press Ping to confirm that a device is connected
User Name
User name for entering the shared PC server, which is decided by
the server
Password
Password for entering the shared PC server, which is decided by the
server
Shared Dir Shared folder directory, cannot be empty
Browse
To enter the Net Disk Browse screen to set the shared folder
directory. And if the user name or the password is incorrect, the
server cannot be entered.
Add Click it to add the Network service to the service list.
Cancel Click to cancel parameter setting
Update To save the changed parameters.
Default To set as the default server for network storage
Delete Click to delete the selected service in the service list.
Exit Click to exit the screen.
 Add a network service:
1. Set the network server properties as described above.
2. Click [Add] to add the service to the Service list.
3. Select the added service in the service list, you can set it as default or delete it.
 Modify a network service:
1. Select the service to be updated in the service list.
2. You can see properties in the Configure Service area.
3. Modify the parameters and click [Update] to update setting.
Tips: in order to make network storage function normally, setting of the sharing folder of
the PC server in advance is a must, e.g. destination, user name and password should be
confirmed at first.
15.9 Manage Settings
The Manage Settings page is used to import or export the setup data or restore factory
setup data.
15.9.1 Exporting Setup Data
This function is used to write all setup data of the system into a disk for backup. The
format of the data file is .DTA.
Procedures: