3-12 System Preparation
Function setting
The function of the footswitch can be set, for details, please refer to “15.1.7 Key
Config”.
3.7.3 Graph /Text printer
Connecting a local printer
As shown in the figure below, a graph /text printer has a power cord and data cable. The
power cord shall be directly connected to a wall receptacle as required.
1. Connect the two USB ports of the printer and the system with the USB cable of the
printer.
2. Power on the system and the printer.
3. Install the printer driver: "[Setup]→ [Peripheral Preset]→[Printer]→[Printer Driver]"
and click [Add Printer], as shown in the figure:
Data cable
USB
connector
Power cord
To Next Page
Loading...
Need help?
General
