3-8 System Preparation
Height adjust
(1) Toggle the lever located at the monitor support arm to the unlocking position
.
(2) Move the monitor support arm up or down to adjust the height.
(3) When you adjust the monitor to a desired position, toggle the lever to the locking
position
and the monitor height is fixed.
NOTE:
Take care of your hands when adjust the monitor up and down.
Rotate the monitor
The monitor can be rotated around its central pivot point for ±90°.
Tilt the monitor
In the process of transportation or moving the system, the deflector rod that is located
the lower left back of the monitor can be toggled left to level the monitor, shown as
follows:
3.5.2 Adjusting Brightness/Contrast on the Monitor
Adjusting the monitor’s brightness and contrast is one of the most important factors for
proper image qualities, if these controls are set incorrectly, the gain, TGC, dynamic range
or even acoustic output have to be changed more often than necessary to compensate.
The adjusting buttons are shown as follows:
To Next Page
Loading...
