298
APPX
Appendix 6 Processing Time
*1 The industrial switch delay time changes depending on the industrial switch model and settings.
*2 A sum of values starting from the smallest value set in "Start" to the largest value set in "End" of "Network Configuration Settings".
*3 This is the device station with the largest calculation value when, for each device station (including extension modules), ("RX Setting"/8)
+ ("RWr Setting" 2) is calculated.
*4 Calculate by rounding up each calculation result in brackets.
*5 When the master station is other than the FX5-CCLGN-MS and the FX5-CCLGN-MS is used as a local station, add a value of p4 to the
"Communication Period Setting" under "Basic Settings" of the master station.
*6 For firmware version "1.010" or earlier
When used as a master station: Total number of points to be set for device stations
When used as a local station (multicast): Total number of points of device stations set at the master station
When used as a local station (unicast): Total number of points set for the own station (FX5-CCLGN-MS) at the master station
For firmware version "1.020" or later
Total number of points to be set for device stations
*7 The relation of dw (Total number of words) and p4 (RX/RY/RWr/RWw data transfer time) is as follows. (Station-based block data
assurance: When "not assured")
When used as a master station
0.00μs
500.00μs
1000.00μs
1500.00μs
2000.00μs
2500.00μs
3000.00μs
3500.00μs
4000.00μs
4500.00μs
5000.00μs
5500.00μs
0 1024 2048 3072 4096 5120 6144 7168 8192 9216
dw
p4
Device station: 60 modules
Device station: 32 modules
Device station: 16 modules
Device station: 1 module
Device station: 60 modules
Device station: 32 modules
Device station: 16 modules
Device station: 1 module
To Next Page
Loading...
