Mitsubishi Electric MELSEC-Q/L - Page 71

2 INSTRUCTION TABLES
2.5 Application Instructions
69
2
Switching instructions
*1 n indicates ([number of file name characters]  2) steps. (Decimal fraction is rounded up.)
X or Y
coordinate
data
SCL2 • Executes scaling for the scaling
conversion data (16-bit data units)
specified by (S2) with the input
value specified by (S1), and then
stores the result into the device
specified by (D). The scaling
conversion is executed based on
the scaling conversion data stored
in the device specified by (S2) and
up.
4  Page 674
SCL2P
DSCL2 • Executes scaling for the scaling
conversion data (32-bit data units)
specified by (S2) with the input
value specified by (S1), and then
stores the result into the device
specified by (D). The scaling
conversion is executed based on
the scaling conversion data stored
in the device specified by (S2) and
up.
4 
DSCL2P
Category Instruction
symbol
Symbol Processing details Execution
condition
Number
of basic
steps
Subset Reference
Block
number
switching
RSET • Converts extension file register
block number to number
designated by (S).
2  Page 677
RSETP
File set QDRSET • Sets file names used as file
registers.
2+n
*1
 Page 679
QDRSETP
QCDSET • Sets file names used as comment
files.
2+n
*1
 Page 681
QCDSETP
Category Instruction
symbol
Symbol Processing details Execution
condition
Number
of basic
steps
Subset Reference
SCL2 S1 S2 D
SCL2P S1 S2 D
DSCL2 S1 S2 D
DSCL2P S1 S2 D
RSET S
RSETP S
QDRSET
File name
QDRSETP
File name
QCDSET
File name
QCDSETP
File name