770
7 APPLICATION INSTRUCTIONS
7.19 Other Instructions
*1 The Universal model QCPU used in the multiple CPU system is turned ON during the online module change of the module controlled by
the other CPU.
• The value of n1 is specified by the first 3 digits of the hexadecimal 4 digits that represent the head I/O number of the
module from which the module information is read.
[QCPU]
[LCPU]
• In any of the following cases, an operation error occurs, the error flag (SM0) turns ON, and an error code is stored into SD0.
*2 For only L06CPU, L06CPU-P, L26CPU, L26CPU-P, L26CPU-BT, and L26CPU-PBT
*3 For only L02SCPU, L02SCPU-P, L02CPU, and L02CPU-P
b12 Module ready status 1: Normal
0: Module error occurred
b13 Empty Fixed to 0
b14 Module type 1: A series module
0: Q series module
Fixed to 0
b15 Module installation status 1: Modules are installed.
0: No modules are installed.
Error
code
Error details Q00J/
Q00/
Q01
QnH QnPH QnPRH QnU LCPU
4100 n1 is a value other than 0 to FFH.
n2 is a value other than 0 to 256.
The total of n1 and n2 is equal to or greater than 257.
*2
n1 is a value other than 0 to 3FH.
n2 is a value other than 0 to 64.
The total of n1 and n2 is equal to or greater than 65.
Q00/
Q01
*3
n1 is a value other than 0 to FH.
n2 is a value other than 0 to 16.
The total of n1 and n2 is equal to or greater than 17.
Q00J
4101 The range of the device specified by (D) exceeds the range from (D) to
(D)+n2 (including (D)).
Bit Item Description
QCPU LCPU
Power
supply
module
CPU QX10 QX10QX10 QX10
Q68
ADV
QY41
P
QY10 QY10
0000
H 0010H 0020H 0030H 0040H 0050H 0070H 0080H
Head I/O number configured in
the I/O assignment setting
Specify K4 or H4 as the head I/O number to be read.
Power
supply
module
CPU
Built-in
I/0
Built-in
CC-Link
LX40
C6
LX40
C6
LX40
C6
L60
AD4
LY41
NT1P
LY10
R2
LY10
R2
LY10
R2
0000
H 0010H 0030H 0040H 0050H 0060H 0070H 0090H 00A0H 00B0H
CPU module
(L26CPU-BT)
Specify K6 or H6 as the head I/O number to be read.
Head I/O number configured in the
I/O assignment setting
To Next Page
Loading...
