Mitsubishi F700 Series User Manual

317
Setting of FR-PU07-01
4
PARAMETERS
4.24.3 PID set point direct setting menu
The setting menu is used to input the PID set point (Pr. 133, Pr. 755) in simple steps under PID control.
Pressing while the FR-PU07-01 is in the monitor mode starts the direct setting mode for the PID set point.
(Valid under PID control. If is pressed while the PID control is invalid, the function menu is displayed.)
REMARKS
In the direct setting mode, parameters can be always read or written regardless of the Pr. 77 and Pr. 160 settings.
PIDset
0. 0 PSI
- - - S T OP HAND
Monitor mode
Function menu
1 MONITOR
2 PU Oper
3 Pr.List
4
Pr.Clear
PIDset pnt1
SET 80.0PSI
FUNC:FUNC MENU
Direct setting mode 1 (Pr. 133)
Direct setting mode 2 (Pr. 755)
Direct setting mode 1 (Pr. 133)
PIDset pnt 1
SET 80.0PSI
SET
0~500
PIDset pnt 2
SET
0~500
Direct setting mode 2 (Pr. 755)
Change the value with the numeric keypad.
Writing of the set value is completed.
The setting is applied to the PID action.
Writing of the set value is completed.
The setting is applied to the PID action.
to
to
(Using / , change the value.)
(Using / , change the value.)
Change the value with the numeric keypad.
SET 40.0PSI
FUNC:FUNC MENU
40.0PSI
SET 40.0PSI
20.0PSI
PIDset pnt2

Mitsubishi F700 Series Specifications

General

Humidity	95% RH or less (non-condensing)
Control Method	V/F control
Protection Features	Overcurrent, overvoltage, undervoltage, overheat, short circuit
Communication Options	RS-485
Operating Temperature	-10°C to +50°C
Storage Temperature	-20°C to +65°C
Altitude	Up to 1000m above sea level
Overload Capacity	150% for 60 seconds
Cooling Method	Forced air cooling
Power Range	0.75 to 630 kW (1 to 845 hp)
Output Voltage	3-phase 200 to 240 VAC, 380 to 500 VAC (matching input voltage)