Mitsubishi F700 Series User Manual

378
Heatsink protrusion attachment procedure
7.4 Heatsink protrusion attachment procedure
When encasing the inverter in an enclosure, the generated heat amount in an enclosure can be greatly reduced by
installing the heatsink portion of the inverter outside the enclosure. When installing the inverter in a compact
enclosure, etc., this installation method is recommended.
7.4.1 When using a heatsink protrusion attachment (FR-A7CN)
For the FR-F740-00023 to 03610, a heatsink can be protruded outside the enclosure using a heatsink protrusion
attachment (FR-A7CN). (Attachment is not required when protruding the heatsink for FR-F740-04320 or larger
inverter.) For a panel cut dimension drawing and an installation procedure of the heatsink protrusion attachment
(FR-A7CN) to the inverter, refer to a manual of "heatsink protrusion attachment (FR-A7CN01 to 11)".
7.4.2 Protrusion of heatsink of the FR-F740-04320 or more
(1) Panel cutting
Cut the panel of the enclosure according to the inverter capacity.
 FR-F740-04320, 04810
(Unit: mm)
 FR-F740-05470, 06100, 06830
(Unit: mm)
 FR-F740-07700, 08660
(Unit: mm)
 FR-F740-09620, 10940, 12120
(Unit: mm)
200 200
484
1395418
985
Hole
6-M10 screw
Hole
300 300
662
1595415
984
6-M10 screw
6-M10 screw
771
1300
21125821
Hole
315
315
8-M10 screw
300 300 300
976
21
150821 1550
Hole

Mitsubishi F700 Series Specifications

General

Humidity	95% RH or less (non-condensing)
Control Method	V/F control
Protection Features	Overcurrent, overvoltage, undervoltage, overheat, short circuit
Communication Options	RS-485
Operating Temperature	-10°C to +50°C
Storage Temperature	-20°C to +65°C
Altitude	Up to 1000m above sea level
Overload Capacity	150% for 60 seconds
Cooling Method	Forced air cooling
Power Range	0.75 to 630 kW (1 to 845 hp)
Output Voltage	3-phase 200 to 240 VAC, 380 to 500 VAC (matching input voltage)