Mitsubishi V5A51 User Manual

V5A51 -
Transmission
23E-5-20
10. Press the reduction brake piston into the transmission
case, and then install the snap ring.
NOTE
Set the open of the snap ring at indicated location.
11. Tighten the reduction brake piston adjusting rod manually
to the full.
12 Adjust t h e reduction brake piston by the following
procedure.
(1) Mount the special tool so that the reduction brake
piston does not rotate.
(2) Mount the torque wrench to the special tool (Socket),
and after repeating tightening and turning back with
a torque of 10 Nm twice, tighten the reduction brake
piston adjusting rod to the specified torque of 5 Nm.
Then turn the reduction brake piston adjusting rod
5
1
/
2
to 5
3
/
4
turns back.
(3) Remove the special tool and tighten the reduction
brake piston nut manually.
AddedPWEE8920-I
E
Mar. 2000Mitsubishi Motors Corporation
Reduction brake piston
Snap ring
MB991693
MB991633
(Socket)

Mitsubishi V5A51 Specifications

General

Brand	Mitsubishi
Model	V5A51
Category	Automobile Parts
Language	English