Mitsubishi V5A51 User Manual

V5A51 -
Transmission
23E-5-22
17. Install the direct annulus gear.
Caution
D
Confirm that the thrust bearing No.10 in the direct
annulus gear is still at the specified location.
18. Apply Vaseline or petrolatum jelly to the thrust bearing
No.9, and then install on the direct annulus gear.
Caution
D
Take care not to mistake the thrust bearing No.9
mounting direction.
19. Apply Vaseline or blue petrolatum jelly on the thrust race
No.8 removed, and then install it on the rear side of the
center support.
Caution
D
Measure and record the thickness of the thrust
race No.8 before assembling.
20. Install the center support.
Caution
D
Install the center support so that the oil hole shown
in the illustration faces the lower side of the
transmission case.
D
Use care that the thrust race No.8 attached to
the rear side of the center support does not fall
off.
AddedPWEE8920-I
E
Mar. 2000Mitsubishi Motors Corporation
Thrust
bearing No.9
Direct annulus
gear
Thrust race No.8

Mitsubishi V5A51 Specifications

General

Brand	Mitsubishi
Model	V5A51
Category	Automobile Parts
Language	English