Mitsubishi V5A51 User Manual

V5A51 -
Transmission
23E-5-32
52. Install a new seal ring onto each accumulator piston.
53. Install each accumulator piston and spring, then install
accumulator cover with O-ring and snap ring.
NOTE
(1) Install the accumulator pistons to the original positions
following the identification tags attached when they
were removed.
(2) The springs are identified by paint application position
as shown below. Assemble following this table.
No. Name Identification paint
application position
1 For overdrive
clutch
None
2 For second
brake
Inner Applied on all surfaces
including both ends
Outer Applied on half of surface
including both ends
3 For
low/reverse
Inner Applied on half of surface
including both ends
brake
Outer Applied on entire surface
of one side
4 For underdrive
clutch
Inner Applied on half of surface
including both ends
Outer Applied on half of surface
including both ends
5 For reduction
brake
None
6 For direct
clutch
None
54. Install the oil strainer and two new oil seals. Install the
oil seals so that the notched section is oriented as shown
in the illustration.
Caution
D
Take care to the installation direction of the oil
seal.
AddedPWEE8920-I
E
Mar. 2000Mitsubishi Motors Corporation
Outer springs
Inner springs
1, 5, 6234
1234
5
6
Oil seals
Oil strainer

Mitsubishi V5A51 Specifications

General

Brand	Mitsubishi
Model	V5A51
Category	Automobile Parts
Language	English