Motorola g20 - Page 141

98-08901C68-O 127
AT Commands Reference
AT+CNMI?
+CNMI: 0,0,0,0,0
OK
AT+CNMI=3,1,0,0,0
OK
4.5.1.8 +CNMA, New Message Acknowledgment
This command acknowledges the receipt of a +CMT response from the terminal to the g20. It confirms the correct reception of
a new SMS-DELIVER message, which was routed directly to the terminal. When the g20 sends a +CMT response to the
terminal, it waits a predefined timeout of 60 seconds for the +CNMA acknowledgment. The g20 will not send another +CMT
result code to the terminal before the previous one is acknowledged, or the timeout expires. Upon receipt of the +CNMA
command, the g20 sends RP-ACK to the network.
If the g20 does not receive acknowledgment within the required time, it sends RP-ERROR to the network. The g20
automatically disables routing to the terminal by setting both <mt> and <ds> values of +CNMI to zero.
If the command is executed but no acknowledgment is expected, or some other g20 related error occurs, the final result code
+CMS ERROR: <err> is returned.
Set Command
Read Command
The Read command for +CNMA is not defined by ETSI, and therefore is not supported by the g20. The g20 returns an error.
Test Command
The Test command for +CNMA is not defined by ETSI, and therefore is not supported by the g20. The g20 returns an error.
Example
AT+CNMI=3,2
OK
+CMT: "+97254565132","2003/4/9,17:14:33"
new message text
AT+CNMA
OK
Command Response/Action
AT+CNMA OK
or:
+CMS ERROR: <err>