Motorola g20 - Page 192

AT Commands Reference
178 98-08901C68-O
4.9.1.5 +CLCK, Facility Lock
This command locks, unlocks or interrogates a g20 or a network facility <fac> (any kind of call barring program). A password
is mandatory for performing locking and unlocking actions, but not for querying. The features of the g20 that are affected by
this are the keypad power-up operation and fixed dialing list. When querying the status of a single call barring program
<mode>=2, the <status> for each call type will be returned.
For <fac>="SC", SIM Card PIN setting and for <fac>="FD", SIM Fixed Dialing memory setting, the <class> is irrelevant (For
more information about <class>, refer to +CLCK Parameters). The <passwd> for "sc" is SIM PIN, and for "fd" it is SIM PIN2.
Set Command
The Set command performs the specified <mode> action on the specified <fac>.
Read Command
Test Command
The Test command returns the list of supported facilities.
Command Response/Action
+CLCK=<fac>,<mode>[,<passwd>
[,<classx>]]
For <fac> where <class> is irrelevant (SC, FD):
+CLCK=<fac>,2
+CLCK: <status>
For <fac> with several supported <class>:
+CLCK=<fac>,2
+CLCK: <status>,<class1>
+CLCK: <status>,<class2>
+CLCK: <status>,<class3>
Command Response/Action
+CLCK? +CLCK: ERROR
Command Response/Action
+CLCK=? +CLCK: (list of supported <fac>s)