Motorola g20 - Page 208

AT Commands Reference
194 98-08901C68-O
Example
ATS24? <enter>
000
OK
ATS24=5 <enter>
OK
ATS24? <enter>
005
OK
(If there are no radio and UART activities, the g20 will enter sleep mode in 5 seconds)
4.10.2.4 S102, Set Delay Before Sending Data to the Terminal
This command sets the value of the delay before sending data to the terminal. Before receiving data, the terminal connected to
the g20 will receive:
• Terminal Wakeup signal (the Wakeup Out Line (pin #26) state will be active low).
• A delay that is equal ATS102 value.
• Data (GPRS, CSD, AT commands' echo and results, unsolicited reports).
Set Command
The Set command sets the delay before sending data to the terminal, and defines a period between sending the wakeup signal
and sending data to the terminal.
Read Command
The Read command returns the current value.
Command Response/Action
ATS102 = <value> OK
Command Response/Action
ATS102? <value>
OK