AT Commands Reference
260 98-08901C68-O
4.16.1.5 System Behavior
The following are the system behavior guidelines while in MUX mode:
• Using the AT+CBAUD and +IPR commands is prohibited while in MUX mode.
• Channels 1 and 2 have the same baud rate and the same hardware flow control.
• Both AT+CMUX and MUX services can be activated without a SIM card (Core AT commands)
• When Channel 1 is in CSD data mode, the connection can be released by sending the +++ sequence, and then sending the
ATH command.
• When Channel 1 is in GPRS data mode, the connection can be released by sending either the +++ sequence, or the ATH
command, or by using the virtual DTR toggle.
• In MUX mode, use the virtual V24 signals as the DTR and DCD hardware signals are not relevant for the MUX protocol.
• AT commands that create unsolicited reports should be set in the MUX mode in order to receive the correct unsolicited AT
command indications (CLCC, CSCB, and so on).
• Activate the +CIPE command before the MUX command in order to receive the correct CIP confirmation in the MUX mode.
• When in CSD data call mode, close the call before exiting the MUX.
4.16.1.5.1 Supported Protocol Services
The following protocol services are supported:
g20 Support Multiplexer ETSI 07.10 - .
Multiplexer Flow Control Service (5.1.8.1.4 in the specifications).
Channel Establishment Services
Purpose: Used to add a new channel.
Usage: Permitted channel ID numbers are 0-2.
Channel Release Services
Purpose: Used to disconnect the existing channel.
Usage: On existing channel.
Data Services
Purpose: Used for data transmissions.
Usage: For data transfer between the g20 and the terminal.
Close Down Services
Purpose: Used to terminate multiplexer 07.10.
Usage: This command can be used if the last existing channel is the control channel (channel 0). The DISC or CLD command
frame can be used for this purpose.
To Next Page
Loading...
