MR TAPCON 250 - Page 103

9 Operation
Maschinenfabrik Reinhausen GmbH 2022 1038595028/00 EN TAPCON
®
250
Description
O: Desired value 5 If a signal is present at the input, the de-
vice activates desired value 5.
O: Function monitoring If a signal is present at the input, the de-
vice activates function monitoring.
O: Collective error If a signal is present at the input, the de-
vice activates the event active function.
O: Undercurrent If a signal is present at the input, the de-
vice activates undercurrent blocking.
O: Overcurrent If a signal is present at the input, the de-
vice activates overcurrent blocking.
O: Undervoltage If a signal is present at the input, the de-
vice activates undervoltage blocking.
O: Overvoltage If a signal is present at the input, the de-
vice activates overvoltage blocking.
O: Motor runtime exceeded If a signal is present at the input, the de-
vice activates the function motor runtime
value above limit.
O: Motor protective switch (pulse) If a signal is present at the input, the de-
vice activates the motor protective
switch.
O: AVR Local/Remote If a signal is present at the input, the de-
vice activates the LOCAL/REMOTE
function.
O: Status Ok If a signal is present at the input, the de-
vice activates the device status.
O: Lower If a signal is present at the input, the de-
vice activates the LOWER function.
O: Raise If a signal is present at the input, the de-
vice activates the RAISE function.
O: TDSC® active If a signal is present at the input, the de-
vice activates the TDSC® function.
Description
O: Desired value setting active If a signal is present at the input, the de-
vice activates desired value active.
O: Desired value setting faulty If a signal is present at the input, the de-
vice activates desired value problem.
O: Auto. If a signal is present at the input, the de-
vice activates the AUTO function.
O: Bandwidth < If a signal is present at the input, the de-
vice activates the function bandwidth
value above limit.