Multitel MX 250 - General Warranty Conditions; Responsibility; Machine Description; Aim of the Machine

Use and warning instructions in compliance with EC regulations - Page 29
no. DESCRIPTION CONDITIONS SPEED (m/s)
3 Gentle breeze Leaves and small twigs constantly moving. 3.3 - 5.4
4
Moderate breeze Dust and loose paper raised; small branches begin to move. 5.5 - 7.9
5
Fresh breeze
Small trees in leaf begin to sway; small waves form in inland bodies
of water.
8 - 10.7
6
Strong breeze Large branches in motion; umbrella use becomes difficult. 10.8- 13.8
7 High wind Whole trees in motion; effort needed to walk against the wind. 13.9 - 17.1
8 Gale Twigs broken from trees; progress on foot is seriously impeded. 17.2 - 20.7
9 Strong gale Light damage to structures (chimneys and roof tiles blown away). 20.8 - 24.4
10 Storme Trees are uprooted, structural damage likely. 24.5 - 28.4
ATTENTION!
Wind speed is measured on average for over 10 minutes at a height of 10 metres, on flat ground.
3.18. GENERAL WARRANTY CONDITIONS
The machine is covered by warranty that takes effect as of the date of delivery to the customer: for the warranty terms,
please refer to the warranty certificate delivered with the machine.
The Manufacturer reserves itself the right to repair replace pieces which are acknowledged to be defective during the
warranty period.
Once the defective piece has been replaced, the Manufacturer is released from any cost incurred by the dealer or the customer,
from any alleged damage, present and future, lost earnings, conventional penalty, cost to rent replacement equipment, etc.
The warranty does not cover the replacement and/or repair of components worn and damaged during regular machine use.
The warranty is forfeited in the event that the rules and instructions for use contained in this manual are not complied with.
Jobs under warranty are carried out during normal business hours at authorized workshops or at the Manufacturer’s facilities.
In case of the job is carried out at the customer’s, travel costs incurred for the technical personnel shall be charged to the
customer. Transport charges for jobs carried out at the Manufacturer’s facilities shall be charged to the customer.
IMPORTANT!
For the general warranty terms and conditions, please refer to the stipulated contract.
3.18.1. RESPONSIBILITY
The manufacturer considers itself released from any and all responsibility and obligation for any event caused by:
♦ failure to comply with the instructions provided in this USE AND MAINTENANCE MANUAL as regards the running, use and
maintenance of the machine;
♦ improper machine use;
♦ non-compliance with legal provisions on safety and with Traffic Regulations;
♦ violent and sudden actions or wrong manoeuvres during machine use and maintenance;
♦ lack of maintenance;