Use and warning instructions in compliance with EC regulations - Page 7
SAFETY STANDARDS AND INSTRUCTIONS FOR USE
1. USE OF THE PLATFORM IS RESERVED FOR AUTHORISED AND TRAINED PERSONNEL.
2. BEFORE USING THE PLATFORM, READ THE USE AND MAINTENANCE MANUAL IN ITS ENTIRETY.
3. DO NOT OPERATE NEAR LIVE ELECTRICAL LINES.
4. USE THE PRESCRIBED SIGNS TO CLOSE OFF THE WORK AREA.
5. BEFORE STARTING OPERATIONS, MAKE SURE NO PERSONS OR OBJECTS ARE INSIDE THE WORK AREA.
6. CHECK THE SOLIDITY OF THE GROUND UPON WHICH TO STABILISE THE PLATFORM. IF NECESSARY, USE PLATES OR
PARTITION BOARDS.
7. USE THE CONTROL LEVEL TO STABILISE AND LEVEL THE PLATFORM AND CHECK THAT THE WHEELS ARE LIFTED.
STABILISATION IS CORRECT WHEN THE GREEN INDICATOR LIGHT SWITCHES ON.
8. DO NOT EXCEED THE MAXIMUM CAPACITY IN THE BASKET.
9. DO NOT USE THE PLATFORM TO LIFT MATERIALS.
10. DO NOT LOAD PERSONS OR MATERIALS ON THE BASKET WHEN IT IS ELEVATED.
11. DO NOT LOAD LARGE SURFACE MATERIALS ON THE BASKET WITH HIGH WIND RESISTANCE.
12. DO NOT USE LADDERS OR STOOLS ON THE BASKET TO INCREASE THE WORK HEIGHT.
13. AVOID CONTACT OF PARTS OF THE PLATFORM WITH FIXED OR MOVABLE OBSTACLES.
14. BEFORE MOVING THE VEHICLE, MAKE SURE THAT THE PLATFORM AND OUTRIGGERS ARE COMPLETELY CLOSED
15. IT IS FORBIDDEN TO REMAIN INSIDE THE BASKET WHILE THE VEHICLE IS MOVING
IMPORTANT
CHECK THE CORRECT OPERATION OF THE SAFETY DEVICES DAILY.
IN CASE OF IRREGULAR OPERATION, IMMEDIATELY PRESS THE EMERGENCY BUTTON.
THE EMERGENCY MANOEUVRES ARE DESCRIBED IN THE USE AND MAINTENANCE MANUAL
The identiļ¬cation plate is located near the control station.
The presence of the plate with CE mark guarantees that the machine was built in compliance with the provisions of European
Community directives.
For any request, always indicate the machine model and serial number.
To Next Page
Loading...