48 Menus you can access while printing
You can check the temperature of the heater during printing.
You can change the pre heater temperature setting for the current print job.
• See the following related sections of Panel Setting Menus:
"**>5: Platen Heater" P. 74
Menu 1: Temperature
[1]
Tap .
[2]
Use or to choose the heater you want to check.
•It displays the current heater temperature and heater temperature
setting in square brackets.
Note
• Indicated temperature is approximate. The accuracy of the temperature is not guaranteed.
• The display of the current temperature blinks all the time even the heater still warms up or has reached the target temperature.
Menu 2: Pre Heater
[1]
Tap .
[2]
Use or to change the value.
• Tap [Enter] to confirm the change.
Note
• The change made is applied to the current job only and is not saved in the
printer.
• To save the change in the user type currently selected, go to “Menu 6:
Backup”.
Temperature 1
Pre Heater: Off
Temperature 2
Platen Heater: 30ºC [50ºC]
Temperature 3
Dryer: 23ºC [30ºC]
Pre Heater:
(30 - 50) 30ºC
To Next Page
Loading...
