NETGEAR WiFi 6 AX1800 User Manual

To disable the DHCP server:
1.
Launch a web browser from a computer or mobile device that is connected to a WiFi
network or LAN port on the AP.
2.
Enter http://www.routerlogin.net in the address field.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Find the IP address of the AP when you cannot use routerlogin.net on page 32.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Setup > LAN Setup.
The LAN Setup page displays.
5. Clear the Use Router as DHCP Server check box.
6. Click the Apply button.
Your settings are saved.
Manage the Router Information Protocol settings [router
mode]
If the AP is in router mode, Router Information Protocol (RIP) lets the AP exchange
routing information with other routers. By default, RIP is enabled in both directions (in
and out) without a particular RIP version.
To manage the RIP settings:
1.
Launch a web browser from a computer or mobile device that is connected to a WiFi
network or LAN port on the AP.
2.
Enter http://www.routerlogin.net in the address field.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Find the IP address of the AP when you cannot use routerlogin.net on page 32.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
User Manual117Network Settings
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204

NETGEAR WiFi 6 AX1800 Specifications

General

WiFi Technology	WiFi 6 (802.11ax)
Maximum WiFi Speed	1.8Gbps
Bands	Dual-band
Ethernet Ports	1 x Gigabit Ethernet
MU-MIMO	Yes
Beamforming	Yes
Security	WPA3
OFDMA	Yes
Wireless Speed	600 Mbps (2.4 GHz) + 1200 Mbps (5 GHz)
Antenna	Internal antennas
Power Source	Power adapter