• Does your computer or device display as an attached device? (See Display the
devices currently on the AP network and change device information on page 158.)
If it does, it is connected to the network.
• Are you using the correct network name (SSID) and password?
Configure WPA and WPA2 Enterprise WiFi
security with a RADIUS server
Remote Authentication Dial In User Service (RADIUS) is an enterprise-level method for
centralized Authentication, Authorization, and Accounting (AAA) management. To
enable the AP to provide WPA and WPA2 enterprise WiFi security, the WiFi network
must be able to reach a RADIUS server.
To configure WPA and WPA2 enterprise security:
1.
Connect your computer or mobile device to the AP in one of the following ways
•
Connect directly to the AP’s WiFi network or LAN. (Applies to the AP in either
operation mode.)
•
Connect to the same network that the AP is connected to. (Applies only if the AP
is operating in AP mode.)
2.
Launch a web browser and enter http://www.routerlogin.net in the address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use routerlogin.net on page 32.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 38.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select BASIC > Wireless.
The Wireless Network page displays.
5. Select the WiFi network (Wireless 1, Wireless 2, or Wireless 3).
6.
In the Security Options section, select the WPA/WPA2 Enterprise radio button.
User Manual68Basic WiFi and Radio Features
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
To Next Page
Loading...
Need help?
General
