• Always. Use service blocking continuously.
6. Click the Add button.
The Block Services Setup page displays.
7. From the Service Type menu, select the service or application to be covered by this
rule.
The Protocol, Starting Port, and Ending Port fields are automatically populated
when you select the service or application.
Note: If the service or application does not display in the list, you can add it by
selecting User Defined from the Service Type menu (see Add a service blocking
rule for a custom service or application [router mode] on page 96).
8.
Specify which devices on your LAN are affected by the rule, based on their IP
addresses:
•
Only This IP Address. Enter the required IP address in the fields to apply the rule
to a single device on your LAN.
•
IP Address Range. Enter the required start and end IP addresses in the fields to
apply the rule to a range of devices.
• All IP Addresses. All computers and devices on your LAN are covered by this
rule.
By default, the All IP Addresses radio button is selected.
9. Click the Add button.
The new rule is added to the Service Table on the Block Services page.
Add a service blocking rule for a custom service or
application [router mode]
If the AP is in router mode, it lists many predefined services and applications that you
can use in outbound rules.
If a service or application is not predefined, you can add a service blocking rule for a
custom service or application.
User Manual96Security, Firewall, and Access
Rules
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
To Next Page
Loading...
Need help?
General
