The BASIC Home page displays.
4. Select BASIC > Wireless.
The Wireless Network page displays.
5. Select the WiFi network (Wireless 2 or Wireless 3).
6. Select a Client Isolation radio button:
•
Enable. All WiFi clients are isolated. That is, WiFi clients that are connected to
the same WiFi network are prevented from communicating with each other.
(Communication over the Internet remains possible.)
•
Disable. WiFi clients that are connected to the same WiFi network are allowed
to communicate with each other.
7. Click the Apply button.
Your settings are saved.
Manage access to LAN ports for clients of
the Wireless 2 or Wireless 3 network
You can manage whether WiFi clients can directly access devices that are connected
to LAN ports of the AP. For example, if you connect a printer to LAN port 3 and a server
to LAN port 4, WiFi clients might be able to access the printer and the server.
Access to LAN ports depends on the WiFi network that the clients are connected to and
whether you enabled such access:
•
Wireless 1. By default, WiFi clients that are connected to the Wireless 1 network
can access devices that are connected to the LAN ports of the AP. For the Wireless
1 network, you cannot disable this type of access.
•
Wireless 2 or Wireless 3. For the Wireless 2 and Wireless 3 networks independently,
you can configure whether WiFi clients can access devices that are connected to the
LAN ports. By default, such access is disabled. (If devices that are connected to the
LAN ports are set up for communication over the Internet, WiFi clients of the Wireless
2 or Wireless 3 network might still be able to reach these devices.)
User Manual73Basic WiFi and Radio Features
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
To Next Page
Loading...
Need help?
General
