To specify whether WiFi clients of the Wireless 2 or Wireless 3 network can access
devices that are connected to the LAN ports:
1.
Connect your computer or mobile device to the AP in one of the following ways
•
Connect directly to the AP’s WiFi network or LAN. (Applies to the AP in either
operation mode.)
•
Connect to the same network that the AP is connected to. (Applies only if the AP
is operating in AP mode.)
2.
Launch a web browser and enter http://www.routerlogin.net in the address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use routerlogin.net on page 32.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 38.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select BASIC > Wireless.
The Wireless Network page displays.
5. Select the Wireless 2 or Wireless 3 button.
The settings for the Wireless 2 or Wireless 3 network display.
6. Scroll down to Allow access to wired ports and select a radio button:
•
Enable. WiFi clients that are connected to the selected network can access devices
that are connected to the LAN ports.
•
Disable. WiFi clients that are connected to the selected network cannot access
devices that are connected to the LAN ports. (If devices that are connected to
the LAN ports are set up for communication over the Internet, WiFi clients might
still be able to reach these devices.)
7. Click the Apply button.
Your settings are saved.
User Manual74Basic WiFi and Radio Features
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
To Next Page
Loading...
Need help?
General
