Enable or disable a WiFi network
You can temporarily disable a WiFi network (that is, an SSID) and you can reenable the
WiFi network.
Note: For information about setting up a WiFi schedule that temporarily turns off a
radio band (and, therefore, all WiFi networks that are active on that band), see Add a
WiFi schedule for a radio on page 200. For information about turning off the radios
entirely (and, therefore, all WiFi networks), see Enable or disable a WiFi radio on page
76.
To disable or enable a WiFi network:
1.
Connect your computer or mobile device to the AP in one of the following ways
•
Connect directly to the AP’s WiFi network or LAN. (Applies to the AP in either
operation mode.)
•
Connect to the same network that the AP is connected to. (Applies only if the AP
is operating in AP mode.)
2.
Launch a web browser and enter http://www.routerlogin.net in the address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use routerlogin.net on page 32.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 38.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select BASIC > Wireless.
The Wireless Network page displays.
5. Select the WiFi network (Wireless 1, Wireless 2, or Wireless 3).
6.
Select one of following VAP radio buttons:
•
Enable. Enables the WiFi network.
By default, the Wireless 2 and Wireless 3 networks are disabled, but you can
enable them.
User Manual70Basic WiFi and Radio Features
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
To Next Page
Loading...
