The BASIC Home page displays.
4.
Select ADVANCED > Advanced Setup > Traffic Meter.
The Traffic Meter page displays.
5.
In the Traffic Control section, clear the Disconnect and disable the Internet
connection check box.
6. Click the Apply button.
Your settings are saved.
Change the system mode to access point
mode or to router mode
By default, the AP functions in router mode, that is, the system mode is router mode.
You can connect the AP to a router, switch, or hub in your network and change the
system mode to access point mode.
The AP can function in either of the following system modes:
•
Router mode. By default, the AP functions in router mode with its router functionality
enabled. When the AP is in router mode, you must connect the WAN (Internet) port
of the AP to a LAN port on your Internet modem. For more information, see Connect
the AP to a modem and log in for the first time on page 28.
•
Access point mode. The AP can function in access point mode with its router
functionality disabled. If the AP is in access point mode, you must connect the WAN
(Internet) port of the AP to a LAN port on a router, switch, or hub in your network.
For more information, see Connect the AP to a routing device and log in for the first
time on page 24.
For information about the features that are enabled in router mode and disabled in
access point mode, see Routing features enabled in router mode on page 38.
To change the system mode to access point mode or back to router mode:
1.
Connect your computer or mobile device to the AP in one of the following ways
•
Connect directly to the AP’s WiFi network or LAN. (Applies to the AP in either
operation mode.)
•
Connect to the same network that the AP is connected to. (Applies only if the AP
is operating in AP mode.)
2.
Launch a web browser and enter http://www.routerlogin.net in the address field.
User Manual166Maintain and Monitor
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
To Next Page
Loading...
Need help?
General
