A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 38.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Setup > Device Name.
The Device Name page displays.
5.
Type a new name in the Device Name field.
You can type up to 15 alphanumeric characters.
6. Click the Apply button.
Your settings are saved.
Reserved LAN IP addresses [router mode]
If the AP is in router mode, you can specify a reserved IP address for a device on the
LAN subnet. Each time such a device accesses the AP’s DHCP server, the device receives
the same IP address.
Note: The information in this section and subsections does not apply if the AP is in
access point mode.
Reserve a LAN IP address [router mode]
You can assign a reserved IP address for a device such as a computer or server that
requires permanent IP settings.
To reserve an IP address:
1.
Launch a web browser from a computer or mobile device that is connected to a WiFi
network or LAN port on the AP.
2.
Enter http://www.routerlogin.net in the address field.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Find the IP address of the AP when you cannot use routerlogin.net on page 32.
User Manual119Network Settings
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
To Next Page
Loading...
Need help?
General
