If your ISP did not give you a VCI string, leave this field blank.
12.
If your ISP gave you a client identifier (client ID) string, enter it in the Client Identifier
String (option 61) field.
If your ISP did not give you a client ID string, leave this field blank.
13.
If your Internet configuration requires a specific VLAN ID, click the VLAN/Bridge
Settings link.
For more information, see Bridge port and VLAN tag groups [router mode] on page
126.
14. Click the Apply button.
Your settings are saved.
15. Click the Test button to test your Internet connection.
If the NETGEAR website does not display within one minute, see one of the following
sections:
•
You cannot access the Internet [router mode] on page 235
•
Troubleshoot Internet browsing on page 238
Specify a PPPoE Internet connection that uses a login [router
mode]
Usually, the quickest way to set up a PPPoE Internet connection is to allow the Setup
Wizard to detect the Internet connection when you go through the initial log-in process
as described in Connect the AP to a modem and log in for the first time on page 28 or,
after initial setup, in Use the Setup Wizard [router mode] on page 41.
After you install the AP and it is in router mode, you can manually specify the PPPoE
Internet connection or change it. (These PPPoE settings are not required if the AP is
operating in AP mode.)
For this procedure, use the settings that your Internet service provider (ISP) gave you.
If you are not sure, contact your ISP.
To specify or view the settings for an ISP Internet connection that uses PPPoE and
that requires a login:
1.
Launch a web browser from a computer or mobile device that is connected to a WiFi
network or LAN port on the AP.
2.
Enter http://www.routerlogin.net in the address field.
A login window displays.
User Manual44Manually Set Up Internet
Settings [Router Mode]
WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
To Next Page
Loading...
Need help?
General
