4.6 Saving/Recalling the Setting and Correction Value into the Memory
4-25 ZM2371/ZM2372
Examples of specifying
Setting (Setting only) ex.) 2 1 Input the numeric value only.
Correction (Correction value only) ex.) .
2 1 Input the decimal point before
numeric value.
Both (Both setting and correction value) ex.)
-
2 1 Input the negative sign before
numeric value.
The target for Save/Recall can be changed by entering the decimal point _._ or negative sign
_
-
_
before defining by the
_
ENTR
_
key. For example, if the
_
-
_
key is pressed after the
target is changed into correction by pressing the _._ key, the target can be changed into both.
Meanwhile, when the target is correction, the target can return to the setting by
additionally pressing the _._ key
After performing Save/ Recall, the target for Save/ Recall turns back to the setting.
Initializing the setting/correction value memory
It is impossible to initialize the contents of setting/correction value memory with the
pressing the
_
SHIFT
_
+ [INIT] ,
_
1
_
keys.
It is possible to initialize the setting/correction value memory by the operation of “Fully
initialization” in system setting menu. However, the setting of interface is also initialized.
For the “Fully initialization” “4.10 Initializing of All Settings”.
To Next Page
Loading...
