NF ZM2371 - 5. REMOTE CONTROL

5-1 ZM2371/ZM2372
5． REMOTE CONTROL
5. REMOTE CONTROL........................................................ 5-1
5.1 Preparations Before Use .................................................. 5-2
5.1.1 Remote Control Interface Selection ...................................... 5-2
5.1.2 Outline of USB ..................................................................... 5-3
5.1.2.1 Preparation of Controller ......................................... 5-3
5.1.2.2 Preparation of ZM2371 / ZM2372 ............................ 5-4
5.1.2.3 USB Device Identification ........................................ 5-4
5.1.3 Outline of RS-232 ................................................................. 5-5
5.1.3.1 Preparation of Controller ......................................... 5-5
5.1.3.2 Preparation of ZM2371 / ZM2372 ............................ 5-5
5.1.3.3 Connection .............................................................. 5-8
5.1.3.4 Difference between RS-232 and USB/GPIB, and
Precautions ............................................................. 5-9
5.1.4 Outline of GPIB .................................................................. 5-10
5.1.4.1 Preparation of Controller ....................................... 5-10
5.1.4.2 Preparation of ZM2372 .......................................... 5-10
5.1.4.3 Precautions on Use of GPIB .................................. 5-10
5.1.4.4 Basic Specifications of GPIB ................................. 5-11
5.1.5 Precautions on Communication .......................................... 5-12
5.2 Switching between Remote State and Local State ......... 5-13
5.3 Response to Interface Message ..................................... 5-14
5.4 Command List ................................................................ 5-15
5.5 Command Tree .............................................................. 5-19
5.6 Command Explanation ................................................... 5-21
5.6.1 Summary of Terms ............................................................. 5-21
5.6.1.1 Subsystem Commands ......................................... 5-21
5.6.1.2 Path Separator ...................................................... 5-21
5.6.1.3 Keywords Simplification ........................................ 5-22
5.6.1.4 Implicit Keywords .................................................. 5-22
5.6.2 Overlap Commands and Sequential Commands ................ 5-22
5.6.3 Command Detailed Explanations ....................................... 5-23
5.6.3.1 Common Commands ............................................. 5-24
5.6.3.2 Subsystem Commands ......................................... 5-28
5.7 Status System ................................................................ 5-75
5.7.1 Status System Overview .................................................... 5-75
5.7.2 Status Byte ......................................................................... 5-76
5.7.3 Standard Event Status ........................................................ 5-77
5.7.4 Operation Status ................................................................ 5-79
5.8 Trigger System ............................................................... 5-82
5.9 Sample Programs .......................................................... 5-84