2.1 Checking Before Use
2-2 ZM2371/ZM2372
2.1 Checking Before Use
Safety check
Before using ZM2371 / ZM2372, make sure you read “Safety Precautions”, Located at the
beginning of this instruction manual and observe the required cautions.
Before turning the power on, read “2.3 Grounding and Power Supply Connection” and
observe the necessary cautions.
Unpacking
Check that the device has not been damaged during transit.
After unpacking, make sure that the contents listed in “Table 2-1 Package Contents” are
supplied.
Table 2–1 Package contents
This device contains high-voltage parts. Never remove the cover.
The internal parts of this device must only be serviced by an engineer who has a
thorough understanding of risk prevention.
Contents of CD-ROM supplied
• Application software
Main settings of ZM2371 / ZM2372, acquisition and display of measured data,
measurement and setting by sweeping the frequencies, and saving of measured data
can be performed.
• LabVIEW driver
The LabVIEW instrument driver that handles the ZM2371 / ZM2372 main commands
and query is provided.
• Sample programs
An example of control of ZM2371 / ZM2372 is shown using each interface of USB,
GPIB, and RS-232 in each programming language of C# , VB.NET and others.
This chapter describes the outline only. For detailed contents and handling method, refer to
the instructions stored in the CD-ROM.
ZM2371 or ZM2372 Body ···················································· 1
Instruction Manual ··························································· 1
CD-ROM (Application Software, etc.) ··································· 1
Power Cord Set (3 Pole, 2 m) ············································· 1
To Next Page
Loading...
